CNC & 3D printer Circuits

1. Length can be customized! ! ！Please write the remarks: Length Continuous.(e.g.: I need 9M length of cable, so I add the choice of “length 1M” 4 times, and “length 5M” 1 time to the shopping cart and pay it. Remark written: Length Continuous)2. Due to the special nature of product , there may not ..

Specifications:Item type: Display ScreenModel number: 2004 LCDPlace of origin: Guangdong, China (Mainland)Condition: New100%Type : LCD Smart Controller ModuleUsage: 3D Printer partsProduct name: 2004 LCD ControllerPackage:2xCable1xAdapter1x2004LCD..

40 mm X 0.35 mm ..

Specifications: Product Name    : Ramps 1.6 Plus Size                       : 101.6*60.19MM PCB            &nb..

Introduction: The DRV8825 stepper motor driver carrier is a breakout board for TI’s DRV8825 micro stepping bipolar stepper motor driver. The module has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver carriers, so it can be used as a higher-performanc..

Specifications:Minimum operating voltage: 8 VMaximum operating voltage: 35 VContinuous current per phase: 1 A2Maximum current per phase: 2 A3Minimum logic voltage: 3 VMaximum logic voltage: 5.5 VMicro step resolutions: full, 1/2, 1/4, 1/8, and 1/16Reverse voltage protection?: NBulk packaged: NHeader..

CNC 3D Printer Kit RAMPS 1.4 Controller Control Panel for Arduino Mega Devlepment BoardFeatures :Standard interfaces (as that of the extruder)Reserved GCI like I2C and RS232MOSFET 3 MOSFET is applied to the heater/ fan and thermistor circuit.Another 5A added to protect the component parts.An 11A fus..

Each road stepper motors only need two IO portsThis expansion board as a driver expansion board, can be used for engraving machines, 3D printers.It is a total of four slots, can drive four A4988 stepper motor.Stepper motor wiring as follows: 2A, 2B is a group (red, green), 1A, 1B is a group (blue, y..

Specifications:3 axis stepper motor driverCompatible with micro-drive laser engraving machine, three-axis CNC engraving machine,.2A can be controlled within the two-phase four-wire stepper motor.Released the digital IO interface, easy to connect to other modules, such as ENDSTOP.Released the I2C int..

Product DescriptionFeatures: 3 axis stepper motor driverCompatible with micro-drive laser engraving machine, three-axis CNC engraving machine2A can be controlled within the two-phase four-wire stepper motor.Released the digital IO interface, easy to connect to other modules, such as ENDSTOP.Rel..

Specifications:Control of 2-phase and 4-phase motorsMaximum signal frequency up to 200 kHzMicro-step up to 1/256 (adjustable), up to 51,200 control pulses per motor revolutionThe possibility of dividing the step on a decimal scaleFull galvanic isolation of inputsOverload protectionSupply voltage: 24..