GSM GPS GPRS Modules

Description:NEO M8 High Precision GPS Navigation and Positioning Module with Signal Amplification Support Arduino and Raspberry PiUsing NEO M8 series multifunctional u-blox M8 GNSS module, the multifunctional GNSS module adopts different models and is easy to manufacture.Receive up to 3 GNSS (GPS, G..

Specifications:Based on Ai-Thinker A6 moduleQuad-band module: 850/900/1800/1900 MHz5V power supply (It has a 3.3V regulator on the card)Maximum current: 2 Ampere (5mA consumption in standby)Control via AT Commands (Baud Rate 115200 bps)Serial Logic Interface up to 3.6V (3.3V Recommended)SMS Messagin..

Specifications:Fully Arduino and Microcontroller CompatibleGSM module: SIM800A RTC backup battery A microphone port A headphone jack RS232 interface selection RS232 serial port lithium battery Interface power input connector power LED (blue) power switch&..

Features:Serial baud rate: 1200 ~ 460800bpsWorking frequency band: 850/900/1800 / 1900MThe control mode: AT command (3GPP TS27.007)GPRS: PPP connection, embedded TCP / IP protocolThe basic functions: dial / answer / SMS / GPRS communicationExtended function: MMS / DTMF / TTS / BluetoothPower supply ..

Specifications:[IC] : SX1278[Frequency] : 410~441MHz[Power] : 10~20dBm[Distance] : 3.0km - 8.0km[Interface] : UART[Weight] : 6.3±0.1g[introduction] : E32-433T20DC is a wireless transceiver module based on SX1278 from SEMTECH(can be transmitter and receiver both). It adopts LoRa spread spectrum techn..

Specifications:Operating Temperature:-30 ~ +80 degrees Standby Current:<3mASupport GSM / GPRS four bands,including 850,900,1800,1900MHzSensitivity:<-105Support Voice CommunicationSupport SMS messageSupport GPRS date service. Max date rate:download?85.6Kbps upload?42.8KbpsSupport standard GSM07..

Specifications:Quad-Band GSM 850/900/1800/1900 MHzGPRS multi-slot class 12/10GPRS mobile station class BCompliant to phase 2/2 +Class 4 (2 W 850/900 MHz)Class 1 (1 W 800/1900 MHz)Control via AT commands (3GPP TS 27.007, 27.005 and Sim Com improved AT Commands)Supply voltage range: 3.4 V ~ 4.4 VGPRS ..

Baud Rate Default Value: 9600bps without battery (this is not safe for airmail) Battery model is MS621FE, need to be weldedPower Supply: 3 - 5 VInterface: RS232 TTLUblox / u-blox NEO-6M GPS Module with built-in antenna and EEPROM. This module is compatible with APM2 and APM2.5, EEPROM stores all set..

Specifications:PCB size: 53 mm X 48mm X 1.6mm Voltage Input: 5-18V Quad-band 850/900/1800/1900MHz GPRS multi-slot class12 connectivity: max. 85.6kbps(down-load/up-load) GPRS mobile station class B Controlled by AT Command (3GPP TS 27.007, 27.005 and SIMCOM enhanced AT Comman..

Specifications:SIM800 module is a GSM/GPRS module. Development board to support China Unicom Mobile 2G/3G/4G card.DC6-24v wide voltage power supply, which also allows your power system to use Windows RDS server. High performance DC-DC power circuit board plus TV protection, allowing the system to im..

Features:Quad-band 850/900/1800/1900MHzConnect onto any global GSM network with any 2G SIM (in the USA, T- Mobile is suggested).Make and receive voice calls using a headset or an external 8 speaker and electret microphone.Send and receive SMS messages.Send and receive GPRS data (TCP/IP, HTTP, etc.) ..

Description:1.Three power input interface: DC044 interface and V_IN and a lithium battery interface.Note that: The range of DC044 and the V_IN pin voltage input is 5 - 26V, when use the 5V as the power, be sure that the power supply can provide 2A current. The range of voltage of Lithium battery inp..

The onboard two set power supply interface VCC5 5V power supply, VCC4 interface, 3.5--4.5V power supply, optional power on self starting (default) and control start.The onboard SMA (default) and IPXmini antenna interface, SIM900A interface reserved reset.The size of the module is 49*50, all the new ..

Features:Boost your wireless coverage with this magnetic mount signal aerial.5 X Range Extender - Extends up to 5 times the original range of your WiFi access in open space.Plug and Play - No extra pigtails needed. Plug directly into your D-link DWL520, Linksys WMP11, WET11, Netgear MA311, or D-link..

Ublox makes good gps. The Ublox NEO-6M gps engine on this board is a quite good one, with high precision binary output. It has also high sensitivity for indoor applications. The gps module have a battery for power backup and EEprom for storing configuration settings.The antenna is connected to modul..

Specifications:Operating voltage: 3.3V (DC)Communication Protocol: UARTSerial communication baud rate: 9600Speed limit: 500m/sHeight restriction: 50000m56 channels, GPS L1 (1575.42Mhz) C / A code, SBAS: WAAS / EGNOS / MSASPositioning accuracy: 2.5mCEP (SBAS: 2.0mCEP)Update rate: Maximum 10Hz (defaul..