Kafuter 100g K-5211 thermal grease CPU not curing thermal grease 1.2 thermal conductivity white

Features

This product uses imported raw materials and formulations production, use, thermal conductivity and good insulating metal oxide and an organic compound from the silicone grease-like paste. Product has excellent thermal conductivity, good electrical insulation, wide temperature (operating temperature -50 ~ + 200 ), good use of stability, low consistency and good workability. This non-toxic, non-corrosive, odorless, quit, do not dissolve.

use

Widely used in heat, filling or coating electronics, electrical appliances, components, to derive the heat generated by components. Such as the CPU and heat sink caulking, power transistor, between the thyristor, diode and the substrate (aluminum, copper) filling the contact of every nip, depending on the machine power amplifier tube and fins, refrigeration and other semiconductors. Lowering the operating temperature of the heat generating element.

Technical performance

Exterior White cream

Penetration (1 / 10mm, 25 ) 260 to 300

Specific gravity (g / cm3) 1.9 to 2.1

Oil from the degree (% .200 , 8h) ≤2.0

Volatile (% .200 , 8h) ≤2.0

Strength Breakdown Voltage (kv / mm) ≥10

Volume resistivity (Ω.cm) 4 × 1014

Thermal conductivity (w / m · k) ≥1.2

Usage: Clean the surface to be coated, remove oil, then heat conductivity silicon ester direct extrusion, uniform coating to the surface to be coated. Coating method may need to be applied by brush, knife or roller.

Note: The construction of the surface should be uniform coating when the coating is not better, but the premise of ensuring fill the gap surface coated with a thin layer can be.

Note: The above data are based on our extensive obtained experimental results are reliable. However, due to the diversity of application conditions of practical application are beyond our control, so users need to be tested before use in order to confirm whether the product is suitable.