Menu
Your Cart

GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board

GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board
GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board
GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board
GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board
GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board
GY-ADS1015 ADS1115 12Bit Analog to Digital Converter ADC Module Breakout Board

Description:

For microcontrollers without an analog-to-digital converter or when you want a higher-precision ADC, the ADS1015 provides 12-bit precision at 3300 samples/second over I2C. The chip can be configured as 4 single-ended input channels, or two differential channels. As a nice bonus, it even includes a programmable gain amplifier, up to x16, to help boost up smaller single/differential signals to the full range. We like this ADC because it can run from 2V to 5V power/logic, can measure a large range of signals and its super easy to use. It is a great general purpose 12 bit converter.

 

The chip's fairly small so it comes on a breakout board with ferrites to keep the AVDD and AGND quiet. Interfacing is done via I2C.

The address can be changed to one of four options (see the datasheet table 5)

so you can have up to 4 ADS1015's connected on a single 2-wire I2C bus for 16 single ended inputs.

 

Feature:

Resolution: 12 Bits

Programmable Sample Rate: 128 to 3300 Samples/Second

Power Supply/Logic Levels: 2.0V to 5.5V

Low Current Consumption: Continuous Mode: Only 150µA Single-Shot Mode: Auto Shut-Down

Internal Low-Drift Voltage Reference

Internal Oscillator

Internal PGA: up to x16

I2C Interface: 4-Pin-Selectable Addresses

Four Single-Ended or 2 Differential Inputs

Programmable Comparator

 

Package Included:

1 X ADS1015 12 bit Precision Analog to Digital Converter

Write a review

Note: HTML is not translated!
Bad Good
Captcha