Relay

Specification:Coil Data @ 23�C Coil Power: Approx 360mW Nominal Voltage: 12.0V Pick up Voltage: 9.0V Maximum Allowable Voltage: 15.6V Coil resistance: 400Ω Contact Data: Contact Resistance: 100milliohm max. (@ 1A 6V) Contact Rating (Res.Load): 10A at 277VAC/28VDC Max. Switching Voltage: 277..

24 Volt 10 Ampere Cube relay This is a sealed 24 volt High quality Single Pole Double Throw (SPDT) Cube Relay. This relays can be used for switching High voltage 230 Volt devices and has current rating upto 10 ampere.  This is a perfect relay if you want to switch low power devi..

Features:*Very convenient to use, simple wiring diagram connection way. RF Remote Control Switch, can through walls.*Support remote control up to 16 pieces. It can connect to the electronic control lock, intercom doorbell, garage door, light, electric curtain, household appliances, motor control, li..

Specifications:Contact form: 1a, 1b, 1cRated load: 10A 250VAC/28VDCCoil resistance: 70 ohmsCoil rated voltage: 3-48VDCCoil pick-up voltage: 5 VDC..

Rated load: 10A 250VAC; 10A 125VAC; 10A 30VDC; 10A 28VDCContact resistance: <=100m (ohm)Electrical life: 100,000Mechanical life: 10,000,000Coil power: 0.36W, 0.45WCoil pick-up voltage: <=75%Coil drop-out voltage: >=10%Ambient temperature: -25 degrees Celsius to +70 degrees CelsiusCoil and c..

Detailed Description:The module complies with international safety standards, control area load area isolation groove;Genuine relay Songle;With the power and relay action instructions, pull bright disconne..

Product AttributesTYPEDESCRIPTIONSELECT ALL CategoriesRelaysSignal Relays, Up to 2 AmpsManufacturerOmron Electronics Inc-EMC DivSeriesG6SPackagingTube Part StatusActiveMounting TypeThrough HoleCoil Voltage5VDCContact FormDPDT (2 Form C)Contact Rating (Current)2ASwitching Voltage250VAC, 220..

Input Voltage : 5-24V DCOutput Voltage : 24-480V AC Output Current : 40AUse a heat sink if Load has + 4A...

Description : 2-Channel Relay interface board,Just use 5V input signal to control.You can do some simple design about it.This module can be used with Arduino Special Sensor Shield V4.0.Each relay has a normally open, normally closed contact group.It can control various appliances and other equi..

Highlights:1. Wide voltage power supply (6 ~ 30V), supports micro USB 5.0V power supply, easy to use;2. The interface is clear, simple, powerful and easy to understand, can meet almost all your needs;3. With emergency stop function (“STOP” button) and reverse polarity protection which can avoid burn..

Use:Temperature measurement, through the potentiometer to adjust to a point, control the corresponding temperature, with the relay output, direct access to the exchange of high power products.Module features:1, automatic control temperature, lower than the start temperature, or higher than the tempe..